How long does the battery last?
The battery in the HT1 sensor generally has a 1 to 2 year lifespan, often closer to two. The HT.w and HTP.xw typically last over 2 years. Battery life is longer in warm conditions and shorter in extreme cold, such as in a freezer.
All three models use a replaceable CR2477 lithium coin cell (a CR2477X is also fine, and is the better choice in a freezer). You will most likely need to purchase the replacement online from a specialized battery retailer. One possible vendor is DigiKey (https://www.digikey.com/product-detail/en/panasonic-bsg/CR2477/P120-ND/107123). They're a very reliable electronic components retailer. Grainger is another good source, as is Mouser Electronics. Please avoid the CR2477N, which has a slightly different shape and will not work. Learn more about choosing a battery.
HT1
When it's time to change it, the process is quick and easy. Just follow these simple instructions in the video below.
IMPORTANT: Before opening the case, dissipate any electrical charge from your body by touching a large, preferably grounded, metal object. The static "zap" you might feel could be enough to damage the sensitive electronics inside your sensor, so be sure to discharge it before you begin.
(Note: the sensor in this video is from an early production run. Later model sensors do not have the additional wires and disc on the inside of the device).
The easiest way to open the case is with an old credit card or similar plastic card. Hold the sensor with the back facing you (the side with the seam) and with the text upright. Using a corner of the credit card, slide back and forth along the top seam pushing inward until the card penetrates slightly (squeezing the left and right sides of the sensor can help).
Then slide the card along the top edge to the left side and pry outward and the back cover will come off. The circuit board will then come out on its own. It's positioned by two plastic pegs but is only held in by the back cover. The battery is on the back of the board. It's a CR2477 lithium coin cell. The + side of the battery should face away from the circuit board.
Reassembly is the reverse, with one trick: it's easier to replace the back cover if you put the top side in first, as the bottom has two smaller pegs that are designed to snap in more easily.
HT.w/HTP.xw:
IMPORTANT: Before opening the battery cap, dissipate any electrical charge from your body by touching a large, preferably grounded, metal object. The static "zap" you might feel could be enough to damage the sensitive electronics inside your sensor, so be sure to discharge it before you begin.
The battery is under the sensor's screw-on battery cap. Unscrew the cap, remove the old battery, and insert the new one with the + side facing up, toward the cap, as shown in the diagram below. Make sure the rubber O-ring is seated in the cap before you screw it back on, so the sensor stays water-resistant.
After you change the battery
Your sensor should start reporting in the app after a few moments. Please don't delete the sensor from the app. If it doesn't show up, open the SensorPush app next to the sensor (if you use a gateway, first turn on Bluetooth in the app's settings) and leave it open for 10 to 15 minutes, then walk through the steps in Why is my sensor not working after I changed the battery?
Going Forward - Here's how to check the battery voltage:
1.) From the home screen with the word "Devices" at the top, please tap the sensor.
2.) Scroll to the bottom of the following screen (this is the screen with the time graph). You should see "Battery voltage."
Anything LESS than 2.3V is when it's too low and you should replace the battery. Also, "BATTERY LOW" appears next to the sensor name once it's low, and if you have alerts turned on for the sensor, the app will send you a low battery alert.